%
- Motorized closing of the porthole.- "Sloping" upper control panel. - Anti-balance control (no necessity for ground anchor). - With "touch screen" (7")embedded computer, multilingual, 200 memory programs (8 programmed from factory). - Super spin-drying 1000 turns/min. (factor-G 300). - Stainless steel tank and basket AISI 304. - Residual humidity 50 %. - Connection cold or hot water. - Upper basin with 3 compartments for washing products_backup_1_1. - Emergency stop button, "Hot shot" kind.-...
%
Tank GN 1/3, delivered with 6 specific baskets, numbered.Thermal lateral handles and stainless steel lid.Heatng resistance, except for tank (standard bain-marie).On/Off switch and thermostat from 0 to 100°C, with limiting device.
%
1 chamber: 830x1260xh180mm.Capacity: 4x 600x400 mm. Stackable oven modules, designed for medium productivity.External construction in AISI 304 stainless steel.The floor of the furnace is made of thermo diffusing steel.Height of the baking vault 180 mm.Ideally suited for baking on platters.Mould made of AISI 430 stainless steel.Heating by shielded resistors on the vault as well as under the floor of the oven.Oven door with stainless steel handle, equipped with a large safety glass.Oura for...
%
Made of stainless steel AISI 304.2 fluorescent tubes with actinic rays (2x 15 W).Low use comparable with 1 lamp of 50 Watt.Voltage 5000 V (grounding when in the case of voltage).Attraction angle 180°, protected surface 100 m2.
%
Made of stainless steel AISI 304.2 fluorescent tubes with actinic rays (2x 15 W).Low use comparable with 1 lamp of 50 Watt.Voltage 5000 V (grounding when in the case of voltage).Attraction angle 360°, protected surface 125 m2.
%
- Air condenser.- Vertical turbine with automatic extraction, low maintenance and very easy to use.- Easy installation due to its compact size.- Minimum mixing capacity 1 liter and maximum 2 liters.- Noise level below 70 dB.- Cycle with time control or with temperature control.- Vertical cylinders-evaporators for a bigger surface of exchange.- Exclusive dispensing device.- Auto diagnostic system.- Cycle time: 10/20 min.- Hourly production: 12 liters.NB: mainly for cold work.
%
- Air condenser.- Vertical turbine with automatic extraction, low maintenance and very easy to use.- Easy installation due to its compact size.- Minimum mixing capacity 1 liter and maximum 2 liters.- Noise level below 70 dB.- Cycle with time control or with temperature control.- Vertical cylinders-evaporators for a bigger surface of exchange.- Exclusive dispensing device.- Auto diagnostic system.- Cycle time: 10/20 min.- Hourly production: 12 liters.NB: mainly for cold work.
%
Superior top 1.5 mm, rounded edge.Ventilated refrigeration with uniform airflows in order to guarantee a homogenous distribution of the cold, even on the shelves of the display, thanks to its particular system of the cold canalization.Pressed basin GN-150 mm, rounded corners, drainage.Display with 3 shelves, opened on customer side.Made in stainless steel AISI 304.Built in hermetic unit.Refrigerant gas R290.
%
Cooling capacity rendered 1960 (W/f) for chamber volume 16,4 m³ / 16400 Lit. (T° internal 0° C & T° external +32° C).Refrigerant expansion by capillary. "Overlapping" refrigeration units.Unit certified in climatic class 5 (40°C Temperature - 40% Humidity).All units are supplied as standard with a high pressure switch and KVL valve.Automatic hot gas defrost with self-evaporation and overflow.The evaporator drain pipe is equipped with a resistor to prevent ice formation. Refrigerant gas...
%
Supplied with one LED lamp (52 Watt). Made of polycarbonate.Conceived for temperatures max. 40°C .Lower hiding place transparent fixed with clips facilitating the dismantling for the maintenance.Protection class IP65
%
Superior top 1.5 mm, rounded edge, pressed 20 mm deep for dimensions GN with rounded corners, drainage.Ventilated refrigeration with uniform airflows in order to guarantee a homogenous distribution of the cold, even on the shelves of the display, thanks to its particular system of the cold canalization.Display with 3 shelves, opened on customer side.Made in stainless steel AISI 304.Built in hermetic unit.Refrigerant gas R290.
%
Superior top 1.5 mm, rounded edge.Ventilated refrigeration with uniform airflows in order to guarantee a homogenous distribution of the cold, even on the shelves of the display, thanks to its particular system of the cold canalization.Pressed basin GN-150 mm, rounded corners, drainage.Display with 3 shelves, opened on customer side.Made in stainless steel AISI 304.Built in hermetic unit.Refrigerant gas R290.
%
Superior top 1.5 mm, rounded edge, pressed 20 mm deep for dimensions GN with rounded corners, drainage.Ventilated refrigeration with uniform airflows in order to guarantee a homogenous distribution of the cold, even on the shelves of the display, thanks to its particular system of the cold canalization.Display with 3 shelves, opened on customer side.Made in stainless steel AISI 304.Built in hermetic unit.Refrigerant gas R290.
%
8W LEDs. Made of AISI 441 stainless steel.Designed for temperatures max. 40°C .Transparent bottom cover fixed with clips for easy disassembly for maintenance.
%
14W LEDs. Made of AISI 441 stainless steel.Designed for high temperatures (+65°).Transparent bottom cover fixed with clips for easy disassembly for maintenance.
%
25W LEDs Made of AISI 441 stainless steel.Designed for temperatures max. 40°C .Transparent bottom cover fixed with clips for easy disassembly for maintenance.
%
25W LEDs. Made of AISI 441 stainless steel.Designed for temperatures max. 40°C .Transparent bottom cover fixed with clips for easy disassembly for maintenance.
%
Superior top 1.5 mm, rounded edges.Plate to keep temperature in vitroceramics.Electric heating by element sited under the tank.Made in stainless steel AISI 304.
%
25W LEDs. Made of AISI 441 stainless steel.Designed for temperatures max. 40°C .Transparent bottom cover fixed with clips for easy disassembly for maintenance.
%
2 Led of 14W. Made of AISI 441 stainless steel.Designed for temperatures max. 40°C .Transparent bottom cover fixed with clips for easy disassembly for maintenance.
%
2 Led of 25W. Made of AISI 441 stainless steel.Designed for temperatures max. 40°C .Transparent bottom cover fixed with clips for easy disassembly for maintenance.
%
2 Led of 25W. Made of AISI 441 stainless steel.Designed for temperatures max. 40°C .Transparent bottom cover fixed with clips for easy disassembly for maintenance.
%
2 Led of 25W. Made of AISI 441 stainless steel.Designed for temperatures max. 40°C .Transparent bottom cover fixed with clips for easy disassembly for maintenance.
%